OpenVZ Forum: Support » How do I access a serial usb device from a VE?

Home » General » Support » How do I access a serial usb device from a VE? (How do I access a serial usb device from a VE?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How do I access a serial usb device from a VE? [message #37749 is a reply to message #37744]

Fri, 16 October 2009 12:55

JimL
Messages: 116
Registered: February 2007

Senior Member

ramjet wrote on Thu, 15 October 2009 17:41

On a 1U HP sever which only has one on-board serial port I added DEVNODES="ttyS0:rw " to the configuration. It's one year ago so I can't remember if I used vzctl:

You will probably need to add DEVNODES="ttyUSB0:rw" but maybe udev on HN will make it more complicated. I can test it tomorrow at work if above doesn't work for you.

The DEVNODES="ttyUSB0:rw" worked perfectly.

Thanks,
Jim.

Report message to a moderator

[Message index]

		How do I access a serial usb device from a VE? By: JimL on Thu, 15 October 2009 18:43
		Re: How do I access a serial usb device from a VE? By: ramjet on Thu, 15 October 2009 21:41
		Re: How do I access a serial usb device from a VE? By: JimL on Fri, 16 October 2009 12:55

Previous Topic:	fork: Cannot allocate memory
Next Topic:	tap device support

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Feb 18 04:18:51 GMT 2026

Total time taken to generate the page: 0.29929 seconds