OpenVZ Forum: Support » How to use two different eth interfaces inside CT

Home » General » Support » How to use two different eth interfaces inside CT

Wed, 19 August 2009 15:06

maratrus
Messages: 1495
Registered: August 2007
Location: Moscow

Senior Member

I suppose Tomp is recommending you the configuration that is described here:
http://wiki.openvz.org/Veth#Virtual_Ethernet_devices_can_be_ joined_in_one_bridge

		How to use two different eth interfaces inside CT By: Mistery on Tue, 18 August 2009 10:27
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:21
		Re: How to use two different eth interfaces inside CT By: tomp on Wed, 19 August 2009 13:24
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:29
		Re: How to use two different eth interfaces inside CT By: maratrus on Wed, 19 August 2009 15:06

Previous Topic:	Creating tun in container fails after following wiki instruction on host
Next Topic:	Sharing Shared Memory ?

Goto Forum:

] [

]

Current Time: Fri Aug 08 10:34:34 GMT 2025

Total time taken to generate the page: 0.13986 seconds