OpenVZ Forum: Support » How to use two different eth interfaces inside CT

Home » General » Support » How to use two different eth interfaces inside CT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to use two different eth interfaces inside CT [message #37120 is a reply to message #37119]

Wed, 19 August 2009 13:29

Mistery
Messages: 8
Registered: August 2009

Junior Member

Currently the VLAN is implemented on the switch itself, not on hardware nodes.
On OpenVZ hardware node I have two physical ethX interfaces connected to different switch's ports on different VLANs
Can you please explain step by step what exactly I need to do on hardware node / CT to try make it working ?
Thanks!

Report message to a moderator

[Message index]

		How to use two different eth interfaces inside CT By: Mistery on Tue, 18 August 2009 10:27
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:21
		Re: How to use two different eth interfaces inside CT By: tomp on Wed, 19 August 2009 13:24
		Re: How to use two different eth interfaces inside CT By: Mistery on Wed, 19 August 2009 13:29
		Re: How to use two different eth interfaces inside CT By: maratrus on Wed, 19 August 2009 15:06

Previous Topic:	Creating tun in container fails after following wiki instruction on host
Next Topic:	Sharing Shared Memory ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Jun 16 12:05:53 GMT 2026

Total time taken to generate the page: 0.25413 seconds