OpenVZ Forum: Russian » ve setup (for dummy)

Home » International » Russian » ve setup (for dummy)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: ve setup (for dummy) [message #35000 is a reply to message #34998]

Thu, 19 February 2009 04:08

GHopper
Messages: 2
Registered: February 2009

Junior Member

Решил поэкспериментировать в одной подсети.
HW:

ghopper@vpsTest:~$ ifconfig
eth0      Link encap:Ethernet  HWaddr 00:17:31:8e:89:55
          inet addr:192.168.7.13  Bcast:192.168.7.255  Mask:255.255.255.0
          inet6 addr: fe80::217:31ff:fe8e:8955/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:6951 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2425 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:554251 (554.2 KB)  TX bytes:691696 (691.6 KB)
          Interrupt:252 Base address:0x8000

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

venet0    Link encap:UNSPEC  HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
          UP BROADCAST POINTOPOINT RUNNING NOARP  MTU:1500  Metric:1
          RX packets:22 errors:0 dropped:0 overruns:0 frame:0
          TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:1394 (1.3 KB)  TX bytes:3480 (3.4 KB)

VE:

root@test101vps:/# ifconfig
lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:6 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:276 (276.0 B)  TX bytes:276 (276.0 B)

venet0    Link encap:UNSPEC  HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
          inet addr:127.0.0.1  P-t-P:127.0.0.1  Bcast:0.0.0.0  Mask:255.255.255.255
          UP BROADCAST POINTOPOINT RUNNING NOARP  MTU:1500  Metric:1
          RX packets:24 errors:0 dropped:0 overruns:0 frame:0
          TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:3608 (3.6 KB)  TX bytes:1506 (1.5 KB)

venet0:0  Link encap:UNSPEC  HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
          inet addr:192.168.7.14  P-t-P:192.168.7.14  Bcast:0.0.0.0  Mask:255.255.255.255
          UP BROADCAST POINTOPOINT RUNNING NOARP  MTU:1500  Metric:1

root@test101vps:/# route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.0.2.1       0.0.0.0         255.255.255.255 UH    0      0        0 venet0
0.0.0.0         192.0.2.1       0.0.0.0         UG    0      0        0 venet0

Странно, но VE имеет интернет! Хотя маршруты вообще бредовые какие-то...

Хочется книжульку, в которой буквы русские и расписано как работает venet (для тупых желательно). А то нифига понимания нету...

Report message to a moderator

[Message index]

		ve setup (for dummy) By: GHopper on Wed, 18 February 2009 16:18
		Re: ve setup (for dummy) By: GHopper on Thu, 19 February 2009 04:08
		Re: ve setup (for dummy) By: maratrus on Thu, 19 February 2009 12:10

Previous Topic:	CentOS5+lilo установка OpenVZ ядра
Next Topic:	Centos 5.2 + ip alias

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Aug 27 18:56:16 GMT 2024

Total time taken to generate the page: 0.06447 seconds