OpenVZ Forum: Support » Problem with DHCP supplied address with bridging

Home » General » Support » Problem with DHCP supplied address with bridging

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Problem with DHCP supplied address with bridging [message #34933 is a reply to message #34932]

Thu, 12 February 2009 16:21

mwolfe
Messages: 4
Registered: February 2009
Location: Raleigh, NC

Junior Member

thanks for the tcpdump tip.. i used it on the VE interface
ie veth555.0 that is bridged to br0.

the problem is that each time the VE for id 555 is stopped
the VE interface veth555.0 is dropped from the bridge.

steps:

host:
- start the VE: vzctl start 555
- add VE interface: brctl addif br0 veth555.0

inside the VE
- dhclient eth0

now i am connected to the lan and outside world
eth0 was bridged at an earlier time.

it seems that i need a startup script to bridge the VE
interface to br0 after starting the VE ?!

Report message to a moderator

[Message index]

		Problem with DHCP supplied address with bridging By: mwolfe on Thu, 12 February 2009 04:27
		Re: Problem with DHCP supplied address with bridging By: schjeall on Thu, 12 February 2009 08:22
		Re: Problem with DHCP supplied address with bridging By: mwolfe on Thu, 12 February 2009 13:55
		Re: Problem with DHCP supplied address with bridging By: schjeall on Thu, 12 February 2009 14:09
		Re: Problem with DHCP supplied address with bridging By: mwolfe on Thu, 12 February 2009 16:21
		Re: Problem with DHCP supplied address with bridging By: maratrus on Thu, 12 February 2009 16:57
		Re: Problem with DHCP supplied address with bridging By: mwolfe on Thu, 12 February 2009 17:09

Previous Topic:	disk inodes not saving, full
Next Topic:	apt-get can't find fzakernel-2.6.18-686-bigmem

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 28 18:06:45 GMT 2026

Total time taken to generate the page: 0.33479 seconds