OpenVZ Forum: Support » Jumbo Frames Support

Home » General » Support » Jumbo Frames Support

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Jumbo Frames Support [message #34374 is a reply to message #34271]

Thu, 25 December 2008 21:11

digidax
Messages: 30
Registered: March 2008

Member

Hello,

ifconfig eth2 mtu 9000 promts me an error:
SIOCSIFMTU: Invalid argument

The same NIC's are running with MTU 9000 at my SAN clusters. I'm using a selfmade SAN: the storage nodes a based on FreeNas, running in synchronous mode on different buildings as HA cluster.

A value of MTU 7000 will be accepted by the NIC on OpenVZ, so I'm thinking, the OVZ kernel / driver combination should be the problem. Thats why I'm interesting in getting informations about the NIC driver in the actual kernel.

best regards
Frank

Report message to a moderator

[Message index]

		Jumbo Frames Support By: digidax on Fri, 19 December 2008 07:53
		Re: Jumbo Frames Support By: piavlo on Wed, 24 December 2008 07:31
		Re: Jumbo Frames Support By: digidax on Thu, 25 December 2008 21:11
		Re: Jumbo Frames Support By: 23max on Sat, 03 January 2009 22:29
		Re: Jumbo Frames Support By: digidax on Sun, 04 January 2009 11:18

Previous Topic:	Missing Debian Lenny packages?
Next Topic:	Creating a VPS with SuSE 10.1

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 17 17:32:15 GMT 2026

Total time taken to generate the page: 0.73445 seconds