OpenVZ Forum


Home » General » Support » *SOLVED* redhat enterprise 4 and mapped/ipv6 ips (FIXED)
Re: redhat enterprise 4 and mapped/ipv6 ips [message #3415 is a reply to message #3396] Fri, 26 May 2006 14:52 Go to previous messageGo to previous message
vmvmvm is currently offline  vmvmvm
Messages: 51
Registered: January 2006
Member
dev wrote on Fri, 26 May 2006 02:36

- kernel version?
- after reboot into OVZ kernel, can you type
# netstat -natp
in the host system please?
- do you use IPv6 at all or it just loaded by RHEL?
- you can turn off IPv6 in /etc/sysconfig/network to test w/o it or if you don't need it at all. Use 'NETWORKING_IPV6=yes|no' parameter.

additional IPv6 info from /etc/sysconfig/network-scripts/ifup-ipv6:



I do not use IPv6 at all. This was a box pre-installed at a datacenter. I had no control over the install of the base OS.

Unfortunatly I also cannot see the console (all remote a c cess)

I added :

NETWORKING_IPV6=no

to /etc/sysconfig/network

and did /sbin/service network restart

but still no luck.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: *SOLVED* need help installing Oracle 10g -- heap error
Next Topic: Enough Resources?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Dec 25 01:22:29 GMT 2025

Total time taken to generate the page: 0.43118 seconds
Powered by FUDforum Powered by Virtuozzo Containers