OpenVZ Forum


Home » General » Support » VLAN not working in VE? <SOLVED>
Re: VLAN not working in VE? [message #33416 is a reply to message #33412] Tue, 14 October 2008 04:00 Go to previous messageGo to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
- First of all, make sure that you've configured eth0 interface inside VE properly
http://wiki.openvz.org/Veth#Simple_configuration_with_virtua l_Ethernet_device

- Then check your routing records inside VE. (make sure that network packets don't leave your VE from venet0 interface.)

- Use tcpdump utility to find out:
* do the packets leave your VE propely
* do they reach HN
* do they leave HN
* does the external node respond
* does the response reach veth interface on the HN
* does the response reach eth* interface inside VE
(try to ping something and at the same moment run tcpdump on eth* interface inside VE, veth* interface on the HN and eth* interface on the HN)

http://wiki.openvz.org/VLAN

Make sure that firewall in the HN/VE allow your VE to communicate with external nodes.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: iptables classifies ESTABLISHED packets as INVALID randomly
Next Topic: *WORKED AROUND* Add /proc/bus/usb inside VE ?
Goto Forum:
  


Current Time: Mon Nov 18 18:36:31 GMT 2024

Total time taken to generate the page: 0.02834 seconds