OpenVZ Forum: Support » privvmpages are failing even if barrier and limit are high enough

Home » General » Support » privvmpages are failing even if barrier and limit are high enough

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: privvmpages are failing even if barrier and limit are high enough [message #33128 is a reply to message #33122]

Wed, 24 September 2008 10:05

disaster
Messages: 158
Registered: February 2006

Senior Member

at the moment it is already set to 12GB and current value is only 1.1GB - i think this should be enough - not?

The following software runs:
qpsmtpd
qmail
stunnel
apache
proftpd
mysql5
mysql4
munin-node

The failcnt is also high directly after boot even when nobody has connected to the ve. Exactly the same image runs also fine on an old PIII with 512MB of RAM.

[Updated on: Wed, 24 September 2008 10:06]

Report message to a moderator

[Message index]

		privvmpages are failing even if barrier and limit are high enough By: disaster on Wed, 24 September 2008 06:35
		Re: privvmpages are failing even if barrier and limit are high enough By: curx on Wed, 24 September 2008 08:42
		Re: privvmpages are failing even if barrier and limit are high enough By: disaster on Wed, 24 September 2008 08:43
		Re: privvmpages are failing even if barrier and limit are high enough By: curx on Wed, 24 September 2008 10:01
		Re: privvmpages are failing even if barrier and limit are high enough By: disaster on Wed, 24 September 2008 10:05

Previous Topic:	Where can we download the "vzstat" source code?
Next Topic:	VE migration failed: Can not dump VE: d_path is invisible

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Sep 02 12:10:08 GMT 2026

Total time taken to generate the page: 0.16176 seconds