OpenVZ Forum


Home » General » Support » Can't start networking on a fedora-9-i386-default-20080913 VE
Re: Can't start networking on a fedora-9-i386-default-20080913 VE [message #33042 is a reply to message #33039] Fri, 19 September 2008 07:16 Go to previous messageGo to previous message
maratrus is currently offline  maratrus
Messages: 1495
Registered: August 2007
Location: Moscow
Senior Member
Quote:


I didn't move or replace the initrd.


But you have to create the new one.
Old initrd contains the modules that are matched to the real ovz005.1 kernel (the kernel you've got from appropriate rpm) not your self compiled one. So modprobe could fail to probe the modules that are not matched your kernel during the boot time.

It's a little bit misleading to do the following
Quote:


cp /usr/src/linux-2.6.24-openvz/arch/i386/boot/bzImage vmlinuz-2.6.24-ovz005.1


cause your kernel is not ovz005.1. it differs.

By the way, why don't you use "make install" command after "make modules_install"?

Hope this helps.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Strange networking problem
Next Topic: VE IP address stops working after several hours
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Jul 14 15:06:29 GMT 2026

Total time taken to generate the page: 0.15456 seconds
Powered by FUDforum Powered by Virtuozzo Containers