OpenVZ Forum


Home » General » Support » Kernel used with slackware?
Re: Kernel used with slackware? [message #32983 is a reply to message #32982] Sun, 14 September 2008 13:21 Go to previous message
penguin_2007 is currently offline  penguin_2007
Messages: 5
Registered: September 2008
Location: Japan
Junior Member
Hi curx and All
It reactivates, and was it thought the situation to be an improvement, and did the problem occur here, is not sda3 still recognized, and is it good the examination of mkinitrd, and making like this, and when solving it very?
# cd /root
# mkinitrd -c -m scsi_mod:sg:sd_mod:libata:sata_nv -r /dev/sda3 -k 2.6.24 -o /boot/initrd-2.6.24.img

※ Excerpt lilo.conf
image = /boot/vmlinuz-2.6.24-ovz
initrd=/boot/initrd-2.6.24.img
root = /dev/sda3
label = Linux-ovz
read-only
# Linux bootable partition config ends

※ Problem
mount : mounting /dev/sda3 on rootdev(or not mounted)
Trouble ahead
You can try to fix it. Type 'exit' when things are done.

※ Input exit
/ bin/sh : can't access tty; job control turned off
/ $ exit
initrd-2.6.24.img : exiting
switch -root:bad newroot /mnt
kernel panic -not syncing : Attempted to kill init!

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: KEEPALIVE: Socket operation error
Next Topic: Supported OS's
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Jul 17 01:56:24 GMT 2026

Total time taken to generate the page: 0.21192 seconds
Powered by FUDforum Powered by Virtuozzo Containers