Re: Server Doesnt Respond After Installing HyperVM/OpenVZ? [message #32887 is a reply to message #32886] |
Sun, 07 September 2008 09:48 ![Go to previous message Go to previous message](/theme/ovz3/images/up.png) ![Go to next message Go to previous message](/theme/ovz3/images/down.png) |
EdwardTobia
Messages: 6 Registered: September 2008 Location: United Kingdom
|
Junior Member |
![edwardtobia%40hotmail.co.uk](/theme/ovz3/images/msnm.png)
|
|
Well im not able to view logs as the server does not come back up from boot, there are no errors in the installation everything goes through fine, its only when i reboot into the OpenVZ kernel, the server does not come back up...
I had a similar problem with one of my other servers, in which i found out that the NIC module was not compiled in the Kernel as it was a new type of NIC, but installing the OpenVZ Development Kernel (Beta) seemed to fix it but in this instance it doesnt...
I have asked 1paket to help but they want to charge me around 350EUR to install OpenVZ on Debian but i require it on CentOS so that i can use HyperVM Slave, but they refuse to give me any help without charging me that amount...
After some testing i managed to get OpenVZ Installed on Ubuntu, but the problem is that HyperVM doesnt support Ubuntu so i need it on CentOS 5, i have no idea as to why its not working on CentOS but works on Ubuntu with the exact same OpenVZ Kernel Version...
Any ideas at all?
All help really appreciated!
Regards,
Edward Tobia
http://www.eurosrv.com - Shared, Reseller, VPS & More!
|
|
|