OpenVZ Forum


Home » General » Support » OpenVZ Density
Re: OpenVZ Density [message #32290 is a reply to message #32273] Wed, 30 July 2008 11:56 Go to previous messageGo to previous message
JimL is currently offline  JimL
Messages: 116
Registered: February 2007
Senior Member
As a practical matter I think you can over commit ram a bunch. Remember that in most cases only a small fraction of the address space of any program needs to be in real memory at any time. The OS takes care of paging stuff in and out of memory for you. You may reach a point by overcommitting that you are thrashing the system, but you can surely overcommit at least 2 - 3 times that and probably a lot more, but that'll depend on your applications. The only real way to know is to try it. Just load a system up with a bunch of ves and put synthetic loads on them. Then bring them up one at a time until the system gets sluggish or worse.

There's no fixed formula that anyone will commit to since it all depends on what the ve's are doing.

Jim.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Remove an ostemplate from openvz
Next Topic: Question on Load Balancing
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 02 19:25:00 GMT 2026

Total time taken to generate the page: 0.12865 seconds
Powered by FUDforum Powered by Virtuozzo Containers