OpenVZ Forum


Home » General » Support » eth0 dies when using openVZ kernel.
Re: eth0 dies when using openVZ kernel. [message #27956 is a reply to message #27918] Tue, 04 March 2008 06:13 Go to previous messageGo to previous message
den is currently offline  den
Messages: 494
Registered: December 2005
Senior Member
Basically, all this output is just routes in the slightly different format that one from 'route' utility. Linux uses 2 tables by default for routing:
- main and
- local.

The latter is used to determine the source address of the outgoing packet and to decide whether the packet is local.

'ip' interface is a bit never in respect to 'route' and is preferred for a lot of people, though it is not compatible with classical Unix one.

For the problem. According to the statitics present, you have 'destination unreachable' error.

So you have listed routing tables after the boot or when you see the problem? We need to see the latter. Additionally, could you share the result of 'ip route get <ip address you are trying to ping>' and 'arp -n' at the moment of the problem?

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Quota Problem
Next Topic: Internet access from VE (again)
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Dec 05 04:12:17 GMT 2025

Total time taken to generate the page: 0.28892 seconds
Powered by FUDforum Powered by Virtuozzo Containers