OpenVZ Forum


Home » General » Support » software RAID1 support on Centos 4.1?
Re: software RAID1 support on Centos 4.1? [message #2601 is a reply to message #2598] Tue, 11 April 2006 08:01 Go to previous messageGo to previous message
dev is currently offline  dev
Messages: 1693
Registered: September 2005
Location: Moscow
Senior Member
thanks!

your SCSI controller
03:05.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1030 PCI-X Fusion-MPT Dual Ultra320 SCSI (rev c1)
is supported by OpenVZ kernel, which you confirmed when said that it boots fine w/o RAID.

mptbase, mptscsih, raid1 are builtin into kernel.

So I suppose 2 possible reasons for your issue:
1. do you use CentOS4.1? not upgraded to 4.3?
2. do you use LVM?
3. check your initrd/grub settings. This is most likely problem I suppose.
4. boot messages would be helpful. Otherwise we need to guess instead of helping you ASAP Smile

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 0:tcpsndbuf running full [was: Could NPTL cause problems?]
Next Topic: Reboot VPS
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Sep 06 00:41:28 GMT 2026

Total time taken to generate the page: 0.06761 seconds
Powered by FUDforum Powered by Virtuozzo Containers