OpenVZ Forum: Support » Routing Class C subnet to VE

Home » General » Support » Routing Class C subnet to VE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Routing Class C subnet to VE [message #25983 is a reply to message #25785]

Mon, 14 January 2008 05:09

zvnepo
Messages: 4
Registered: January 2008

Junior Member

OK, so if we understand correctly, using veth w/o bridging, a static route can be setup from eth0 on the host to the VE vethVEID.0 device? That would be a more secure solution. Now to just figure out the static route needed.

Report message to a moderator

[Message index]

		Routing Class C subnet to VE By: zvnepo on Wed, 09 January 2008 04:48
		Re: Routing Class C subnet to VE By: vaverin on Wed, 09 January 2008 09:35
		Re: Routing Class C subnet to VE By: zvnepo on Thu, 10 January 2008 20:51
		Re: Routing Class C subnet to VE By: vaverin on Fri, 11 January 2008 07:05
		Re: Routing Class C subnet to VE By: zvnepo on Mon, 14 January 2008 04:02
		Re: Routing Class C subnet to VE By: vaverin on Mon, 14 January 2008 05:05
		Re: Routing Class C subnet to VE By: zvnepo on Mon, 14 January 2008 05:09
		Re: Routing Class C subnet to VE By: vaverin on Mon, 14 January 2008 05:20

Previous Topic:	RHEL5 template?
Next Topic:	process check

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Feb 15 21:55:02 GMT 2026

Total time taken to generate the page: 0.71815 seconds