OpenVZ Forum


Home » General » Support » VE: XXX: failed to start with err=-11
Re: VE: XXX: failed to start with err=-11 [message #25884 is a reply to message #25727] Thu, 10 January 2008 10:13 Go to previous messageGo to previous message
yettyn is currently offline  yettyn
Messages: 31
Registered: January 2008
Location: Jihlava, CZ
Member
yettyn wrote on Tue, 08 January 2008 11:25

I had this issue as well after creating my own ve-vps.conf-sample with vzsplit, replacing ve-vps.basic.conf-sample. It turned out vz set all to low and wrong values for quota and inodes, so in some cases I couldn't even create a VE as just the template caused the quota hardlimit to trigger Smile

I think you can test this simple by setting DISK_QUOTA=no, if it works then you have found your problem Wink

/Joakim

Correcting myself as this has started again, same pattern but I get err=-17 and now nothing seem to help, even if I switch off disk quota and give plenty of resourses... still can run max 1 VE Sad

/Joakim


Kernel 2.6.32-125.3
vzctl 4.9.4
Gentoo Linux x64
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Changing a pre-created OS template
Next Topic: VPS Broadcast and Gateway IP
Goto Forum:
  


Current Time: Tue Aug 12 09:45:01 GMT 2025

Total time taken to generate the page: 0.57570 seconds