OpenVZ Forum: Support » VE: XXX: failed to start with err=-11

Home » General » Support » VE: XXX: failed to start with err=-11

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: VE: XXX: failed to start with err=-11 [message #25727 is a reply to message #25601]

Tue, 08 January 2008 10:25

yettyn
Messages: 31
Registered: January 2008
Location: Jihlava, CZ

Member

I had this issue as well after creating my own ve-vps.conf-sample with vzsplit, replacing ve-vps.basic.conf-sample. It turned out vz set all to low and wrong values for quota and inodes, so in some cases I couldn't even create a VE as just the template caused the quota hardlimit to trigger Smile

I think you can test this simple by setting DISK_QUOTA=no, if it works then you have found your problem Wink

/Joakim

Kernel 2.6.32-125.3
vzctl 4.9.4
Gentoo Linux x64

Report message to a moderator

[Message index]

		VE: XXX: failed to start with err=-11 By: patrikweb on Wed, 02 January 2008 23:18
		Re: VE: XXX: failed to start with err=-11 By: vaverin on Thu, 03 January 2008 07:55
		Re: VE: XXX: failed to start with err=-11 By: patrikweb on Thu, 03 January 2008 10:26
		Re: VE: XXX: failed to start with err=-11 By: vaverin on Tue, 08 January 2008 07:07
		Re: VE: XXX: failed to start with err=-11 By: yettyn on Tue, 08 January 2008 10:25
		Re: VE: XXX: failed to start with err=-11 By: patrikweb on Tue, 08 January 2008 23:21
		Re: VE: XXX: failed to start with err=-11 By: yettyn on Thu, 10 January 2008 10:13
		Re: VE: XXX: failed to start with err=-11 By: dev on Fri, 11 January 2008 12:57
		Re: VE: XXX: failed to start with err=-11 By: patrikweb on Fri, 11 January 2008 13:02
		Re: VE: XXX: failed to start with err=-11 By: dev on Fri, 11 January 2008 13:05
		Re: VE: XXX: failed to start with err=-11 By: yettyn on Fri, 11 January 2008 13:16
		Re: VE: XXX: failed to start with err=-11 By: patrikweb on Mon, 14 January 2008 22:31
		Re: VE: XXX: failed to start with err=-11 By: vaverin on Tue, 15 January 2008 05:08
		Re: VE: XXX: failed to start with err=-11 By: yettyn on Fri, 11 January 2008 13:09

Previous Topic:	Changing a pre-created OS template
Next Topic:	VPS Broadcast and Gateway IP

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 29 20:37:20 GMT 2026

Total time taken to generate the page: 0.41132 seconds