OpenVZ Forum


Home » General » Support » Unable to open pty
Re: Unable to open pty [message #24640 is a reply to message #24630] Fri, 07 December 2007 07:05 Go to previous messageGo to previous message
vaverin is currently offline  vaverin
Messages: 708
Registered: September 2005
Senior Member
"vzctl enter" fails because it cannot find device file. Centos 4 uses udev to create device files. If Your VE uses udev -- it should create this device file inside Your VE automaticaly,
If your VE does not use udev -- it should have pre-dreated devices files inside /dev directory.

- Could You please check is udev started inside Your VE (ps ax | grep udev)?
- Could You please show the mounts inside Your VE (cat /proc/mounts)
- Could You please show existing device files inside Your VE (ls /dev -al)?

thank You,
Vasily Averin

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: bnx2 module missing
Next Topic: iptables NAT support for a single container
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Dec 10 18:47:40 GMT 2025

Total time taken to generate the page: 0.33299 seconds
Powered by FUDforum Powered by Virtuozzo Containers