OpenVZ Forum: Support » Problem Inserting Microcode (Wrong arch?)

Home » General » Support » Problem Inserting Microcode (Wrong arch?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Problem Inserting Microcode (Wrong arch?) [message #24314 is a reply to message #24313]

Mon, 03 December 2007 22:52

btgeekboy
Messages: 3
Registered: December 2007

Junior Member

I just confirmed I was able to use insmod to fix the problem. Then running `modprobe microcode` works without an issue.

It appears the init.d script simply runs `/sbin/modprobe microcode`, so I guess we could hack the init script to fix the problem, but that's treating the symptom rather than addressing the root cause.

Perhaps this is worthy of a bug report?

Report message to a moderator

[Message index]

		Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Mon, 03 December 2007 19:12
		Re: Problem Inserting Microcode (Wrong arch?) By: tomp on Mon, 03 December 2007 22:33
		Re: Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Mon, 03 December 2007 22:52
		Re: Problem Inserting Microcode (Wrong arch?) By: kir on Tue, 04 December 2007 08:39
		Re: Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Tue, 04 December 2007 09:13
		Re: Problem Inserting Microcode (Wrong arch?) By: kir on Tue, 04 December 2007 09:16
		Re: Problem Inserting Microcode (Wrong arch?) By: mohaw on Tue, 04 December 2007 13:03
		Re: Problem Inserting Microcode (Wrong arch?) By: khorenko on Tue, 04 December 2007 14:21

Previous Topic:	help
Next Topic:	unable to install cubepanel in VE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jul 15 04:12:47 GMT 2026

Total time taken to generate the page: 0.15093 seconds