OpenVZ Forum: Support » Problem Inserting Microcode (Wrong arch?)

Home » General » Support » Problem Inserting Microcode (Wrong arch?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Problem Inserting Microcode (Wrong arch?) [message #24313 is a reply to message #24301]

Mon, 03 December 2007 22:33

tomp
Messages: 64
Registered: August 2007

Member

Hi

I am in the identical situation to you. I too have a Dell 1950 server with nothing installed except the ovz kernel and Dell openmanage software all installed via yum.

If i insmod the microcode module from the x64 lib folder then there are no errors when i run modprobe microcode. However running the command by itself generates the same errors as appear on boot.

Report message to a moderator

[Message index]

		Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Mon, 03 December 2007 19:12
		Re: Problem Inserting Microcode (Wrong arch?) By: tomp on Mon, 03 December 2007 22:33
		Re: Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Mon, 03 December 2007 22:52
		Re: Problem Inserting Microcode (Wrong arch?) By: kir on Tue, 04 December 2007 08:39
		Re: Problem Inserting Microcode (Wrong arch?) By: btgeekboy on Tue, 04 December 2007 09:13
		Re: Problem Inserting Microcode (Wrong arch?) By: kir on Tue, 04 December 2007 09:16
		Re: Problem Inserting Microcode (Wrong arch?) By: mohaw on Tue, 04 December 2007 13:03
		Re: Problem Inserting Microcode (Wrong arch?) By: khorenko on Tue, 04 December 2007 14:21

Previous Topic:	help
Next Topic:	unable to install cubepanel in VE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Sep 06 01:01:33 GMT 2026

Total time taken to generate the page: 0.05613 seconds