OpenVZ Forum


Home » General » Support » Cannot Start VE - Unable to set capability: Operation not permitted
Re: Cannot Start VE - Unable to set capability: Operation not permitted [message #23293 is a reply to message #23290] Thu, 15 November 2007 09:58 Go to previous messageGo to previous message
JFOC is currently offline  JFOC
Messages: 13
Registered: September 2007
Location: http://www.jfoc.net - htt...
Junior Member

Quote:


I would note that it is enough for VE networking via venet interface
http://wiki.openvz.org/Virtual_network_device
veth interface is an alternative soulution, and you can not use it at all.


Why i cannot use this ?

Quote:


this rule means that all forwarded packets will have source ip=209.250.234.162. Is it your hardware node's IP?


Yes that's 209.250.234.162 is my static ip for server

Quote:


As far as I see you cannot translate jfoc.net name to IP. Are you sure that you have started nameserver on your hardware node? If not -- you can set to VE the same nameserver that uses your hardware node.

Then let's check the following:
- do you able to ping HW node from inside VE (by using its IP)?
- do you able to ping some external IP from inside VE?


- Yes i'm sure the nameserver has been running well, because this is dedicated server for web hosting.
- I cannot ping HW node from Inside VE (using name / ip)
- I cannot ping any external IP from VE


 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: "vzctl stop" - hangs
Next Topic: May be a Bug
Goto Forum:
  


Current Time: Wed Jul 10 03:19:14 GMT 2024

Total time taken to generate the page: 0.02446 seconds