OpenVZ Forum


Home » General » Support » IPCop template
Re: IPCop template [message #22819 is a reply to message #22760] Mon, 05 November 2007 01:04 Go to previous messageGo to previous message
nschembr is currently offline  nschembr
Messages: 5
Registered: October 2007
Location: pa usa
Junior Member
Ok, I'm stuck.

The port is very easy, but Ip table inside the ve is an issue.

tt's very fast to make the smoothwall template.

I used http://wiki.openvz.org/Physical_to_VE to create the image.

I used the Virtual ethernet devices can be joined in one bridge section from http://wiki.openvz.org/Veth#Simple_configuration_with_virtua l_ethernet_device to create two bridges. one green and one red. The HN shared the red bridge with the ve.


The VE has a issue with iptables. I worked with “Re: iptables with nat inside guest”, http://forum.openvz.org/index.php?t=msg&goto=22599&

An Iptables expert is needed for this port.

I'm going to install kvm and run the guest inside the vm. I will post the howto

Nicholas A. Schembri
State College PA USA

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: What's the password for CentOS4.4 liveCD with OpenVZ?
Next Topic: git inside VPS fails on mmap
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Jul 12 21:24:12 GMT 2026

Total time taken to generate the page: 0.29475 seconds
Powered by FUDforum Powered by Virtuozzo Containers