OpenVZ Forum: Support » Centos 5 and adaptec RAID card=trouble

Home » General » Support » Centos 5 and adaptec RAID card=trouble

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Centos 5 and adaptec RAID card=trouble [message #22169 is a reply to message #22162]

Mon, 22 October 2007 22:33

dranch
Messages: 33
Registered: August 2007

Member

I don't see any problems here in your kernel boot output

The Adaptec driver seems to see your partitions just fine (sda1, sda2, sda3). Note that sata1 and sata2 are probably motherboard SATA connections that aren't in use.

One problem I *DO* see is that your mkinitrd isn't installing your
aar81xx module. It tries to figure out any dependencies but it doesn't copy it over. That's bad and probably the root of your issue if you try to use a modularized kernel.

--David

Report message to a moderator

[Message index]

		Centos 5 and adaptec RAID card=trouble By: bryonovz on Sun, 21 October 2007 19:33
		Re: Centos 5 and adaptec RAID card=trouble By: dranch on Mon, 22 October 2007 16:02
		Re: Centos 5 and adaptec RAID card=trouble By: bryonovz on Mon, 22 October 2007 17:08
		Re: Centos 5 and adaptec RAID card=trouble By: dranch on Mon, 22 October 2007 22:33
		Re: Centos 5 and adaptec RAID card=trouble By: bryonovz on Mon, 22 October 2007 22:51

Previous Topic:	NFS mounts disappearing from OAS servers
Next Topic:	openvz and ppp

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Aug 30 08:18:49 GMT 2026

Total time taken to generate the page: 0.61348 seconds