David wrote:
> Why can't you just add a helper function to sched.c:
> 
> 	void set_hotcpus_allowed(struct task_struct *task,
> 				 cpumask_t cpumask)
> 	{
> 		mutex_lock(&sched_hotcpu_mutex);
> 		set_cpus_allowed(task, cpumask);
> 		mutex_unlock(&sched_hotcpu_mutex);
> 	}
> 
> And then change each task's cpus_allowed via that function instead of 
> set_cpus_allowed() directly?

I guess this would avoid race conditions within the set_cpus_allowed()
routine, between its code to read the cpu_online_map and set the tasks
cpus_allowed ... though if that's useful, don't we really need to add
locking/unlocking on sched_hotcpu_mutex right inside the
set_cpus_allowed() routine, for all users of set_cpus_allowed ??

But I don't see where the above code helps at all deal with the
races I considered in my previous message:

> My solution may be worse than that.  Because set_cpus_allowed() will
> fail if asked to set a non-overlapping cpumask, my solution could never
> terminate.  If asked to set a cpusets cpus to something that went off
> line right then, this I'd guess this code could keep looping forever,
> looking for cpumasks that didn't match, and then not noticing that it
> was failing to set them so as they would match.

These races involve reading the tasks cpuset cpus_allowed mask, reading
the online map, and both reading and writing the tasks task_struct
cpus_allowed.  Unless one holds the relevant lock for the entire
interval surrounding the critical accesses to these values, it won't do
any good that I can see.  Just briefly holding a lock around each
separate access is useless.

-- 
                  I won't rest till it's the best ...
                  Programmer, Linux Scalability
                  Paul Jackson <pj@sgi.com> 1.925.600.0401
_______________________________________________
Containers mailing list
Containers@lists.linux-foundation.org
https://lists.linux-foundation.org/mailman/listinfo/containers