OpenVZ Forum: Support » deriving a configuration from the example configs

Home » General » Support » deriving a configuration from the example configs

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: deriving a configuration from the example configs [message #20542 is a reply to message #20499]

Thu, 20 September 2007 12:07

vaverin
Messages: 708
Registered: September 2005

Senior Member

>I think that if i use the 2GBytes/120VEs example configuration(without any changes) on my system , i get a system which can support 240 VEs,then i can multiply the UBC parameters by 2 and get a 4GBytes/120VE system.Am i right?

It isn't correct. Some resources have limits that are not depend on total RAM size on the node.

I would like to recommend you to use vzsplit utility.

thank you,
Vasily Averin

Report message to a moderator

[Message index]

		deriving a configuration from the example configs By: UI_ICT on Mon, 10 September 2007 11:03
		Re: deriving a configuration from the example configs By: UI_ICT on Wed, 19 September 2007 08:36
		Re: deriving a configuration from the example configs By: vaverin on Thu, 20 September 2007 12:07

Previous Topic:	Cant patch vanilla 2.6.22.6 with OVZ
Next Topic:	Side effects of enabling CAP_SYS_TIME inside VE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 20 11:48:42 GMT 2025

Total time taken to generate the page: 0.06927 seconds