OpenVZ Forum: Support » using network aliases

Home » General » Support » using network aliases

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

using network aliases [message #2011]

Tue, 14 March 2006 12:05

bhazeltn
Messages: 5
Registered: March 2006

Junior Member

I'm trying to assign eth0:2 to a vps, but I can't seem to figure it out

mainserv bradley # ifconfig eth0:2
eth0:2    Link encap:Ethernet  HWaddr xx:xx:xx:xx:xx:xx  
          inet addr:xxx.xxx.xxx.xxx  Bcast:xxx.xxx.xxx.xxx Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          Interrupt:11 Base address:0xc000

mainserv bradley # vzctl set 101 --netdev_add eth0:2
Unable to add netdev eth0:2: No such process

Is there a way to do this?

Report message to a moderator

[Message index]

		using network aliases By: bhazeltn on Tue, 14 March 2006 12:05
		Re: using network aliases By: kir on Tue, 14 March 2006 13:31
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 15:51
		Re: using network aliases By: kir on Tue, 14 March 2006 15:57
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 16:44
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 17:53
		Re: using network aliases By: bhazeltn on Tue, 14 March 2006 16:07

Previous Topic:	Question about memory resource parameters
Next Topic:	iptables in vps or on the host node

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Aug 29 09:56:23 GMT 2026

Total time taken to generate the page: 0.36450 seconds