OpenVZ Forum: Support » deriving a configuration from the example configs

Home » General » Support » deriving a configuration from the example configs

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

deriving a configuration from the example configs [message #16503]

Mon, 10 September 2007 11:03

UI_ICT
Messages: 3
Registered: September 2007
Location: UI

Junior Member

The http://wiki.openvz.org/UBC_configuration_examples_tableexample configurations are for a system with 2 Gbytes of RAM, for example 2GBytes/120VEs .
the system i have has 4 Gbytes of RAM, how can i get an equivalant system that has 4GBytes/120VEs?

I think that if i use the 2GBytes/120VEs example configuration(without any changes) on my system , i get a system which can support 240 VEs,then i can multiply the UBC parameters by 2 and get a 4GBytes/120VE system.Am i right?

[Updated on: Mon, 10 September 2007 11:04]

Report message to a moderator

[Message index]

		deriving a configuration from the example configs By: UI_ICT on Mon, 10 September 2007 11:03
		Re: deriving a configuration from the example configs By: UI_ICT on Wed, 19 September 2007 08:36
		Re: deriving a configuration from the example configs By: vaverin on Thu, 20 September 2007 12:07

Previous Topic:	Cant patch vanilla 2.6.22.6 with OVZ
Next Topic:	Side effects of enabling CAP_SYS_TIME inside VE

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 29 21:27:52 GMT 2026

Total time taken to generate the page: 0.43340 seconds