OpenVZ Forum: Support » Setting RAM

Home » General » Support » Setting RAM

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Setting RAM [message #159 is a reply to message #153]

Fri, 23 September 2005 08:17

kir
Messages: 1645
Registered: August 2005
Location: Moscow, Russia

Senior Member

Setting user beancounter parameters is an advanced task (described in soon-to-be-released SLM Guide). Basically, all the parameters are inter-dependant and you can not just change one parameter and hope it will work. So you'd better stick to existing config samples, or at least use vzcfgvalidate to check your new config for validity.

And yes, privvmpages parameter's unit is pages. On ix86 architecture a page is equal to 4096 bytes, or 4 kilobytes.

Kir Kolyshkin

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]

		Setting RAM By: devnu11 on Fri, 23 September 2005 04:22
		Re: Setting RAM By: kir on Fri, 23 September 2005 08:17
		Re: Setting RAM By: devnu11 on Wed, 05 October 2005 20:58
		Re: Setting RAM By: dim on Thu, 06 October 2005 08:11
		Re: Setting RAM By: kir on Thu, 06 October 2005 08:28
		Re: Setting RAM By: kir on Mon, 10 October 2005 08:25

Previous Topic:	VZ kernel RPM help.
Next Topic:	Networking in OpenVZ

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 11 15:42:04 GMT 2026

Total time taken to generate the page: 0.52125 seconds