OpenVZ Forum


Home » General » Support » *solved* OpenVZ on CentOS 5 network issues
Re: OpenVZ on CentOS 5 network issues [message #15832 is a reply to message #15829] Tue, 14 August 2007 22:34 Go to previous messageGo to previous message
locutius is currently offline  locutius
Messages: 125
Registered: August 2007
Senior Member
packet forwarding was enabled and if you read the posters reply he tells you packet forwarding reset to default disabled on HN reboot

it is all ok for you to turn up 48 hours later and say OpenVZ is well supported when for 24 hours there was zero interest in the poster's topic and seeking stability he was forced to re-install an old operating system. the poster's experience is that OpenVZ is not well supported

it is all very well for you to say OpenVZ is well supported when 48 hours after sending a mail to sales@OpenVZ asking to purchase a support contract the poster has received zero reply

the poster has 5 years linux admin experience, has 3 multi-processor production machines, and knows how to read

as this topic demonstrates the poster is working hard to discover tweaks to your system that are apparently hidden and NOT in the wiki e.g. nameserver

is the problem for you that the poster is stubborn and is persisting in the attempt to configure OpenVZ? what exactly is your problem that you post a flame without reading the poster's topic? the poster's experience of the OpenVZ forum is laid out for all to see

the poster is attempting the most basic install possible. a virgin CentOS with the objective of multiple VE all with external IPs. and you turn up to patronise without a single word of assistance

finally:

this looks wrong in sysctl.conf

# Do not accept source routing
net.ipv4.conf.default.accept_source_route = 0

should it be 1?

[Updated on: Tue, 14 August 2007 22:52]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: change inode_soft_limit
Next Topic: Problematic Hard Disk - Read Only Mode
Goto Forum:
  


Current Time: Sat Aug 16 13:46:26 GMT 2025

Total time taken to generate the page: 0.15140 seconds