OpenVZ Forum: Support » IPCop template

Home » General » Support » IPCop template

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IPCop template [message #15517 is a reply to message #15515]

Thu, 02 August 2007 21:44

marc1911
Messages: 11
Registered: August 2007

Junior Member

Okay. But what about the section "Moving Network Adapter to Virtual Private Server" on page 68 of the Chapter "Advanced Tasks" in the OpenVZ Users Guide? I've read that just after your reply and it says that there's a possibility for a VPS to directly access the physical network adapter. The following command would make that possible:

# vzctl set 101 --netdev_add eth1 --save

It has some limitations though, one of them is that the device is only accessible to the VPS. Hardware node and other VPS's thus excluded.

Report message to a moderator

[Message index]

		IPCop template By: marc1911 on Thu, 02 August 2007 18:34
		Re: IPCop template By: ugob on Thu, 02 August 2007 18:42
		Re: IPCop template By: marc1911 on Thu, 02 August 2007 19:01
		Re: IPCop template By: ugob on Thu, 02 August 2007 19:23
		Re: IPCop template By: marc1911 on Thu, 02 August 2007 21:44
		Re: IPCop template By: ugob on Thu, 02 August 2007 21:48
		Re: IPCop template By: marc1911 on Thu, 02 August 2007 21:56
		Re: IPCop template By: nschembr on Tue, 30 October 2007 19:01
		Re: IPCop template By: nschembr on Fri, 02 November 2007 04:02
		Re: IPCop template By: nschembr on Fri, 02 November 2007 05:02
		Re: IPCop template By: nschembr on Fri, 02 November 2007 21:22
		Re: IPCop template By: nschembr on Mon, 05 November 2007 01:04
		Re: IPCop template By: sjdean on Fri, 30 May 2008 18:46

Previous Topic:	What's the password for CentOS4.4 liveCD with OpenVZ?
Next Topic:	git inside VPS fails on mmap

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 31 17:50:54 GMT 2026

Total time taken to generate the page: 0.16136 seconds