OpenVZ Forum: Support » *DISCUSSION* OVZ command to start/stop VE based on status.

Home » General » Support » *DISCUSSION* OVZ command to start/stop VE based on status.

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: OVZ command to start/stop VE based on status. [message #14730 is a reply to message #14722]

Mon, 09 July 2007 10:00

n00b_admin
Messages: 77
Registered: July 2006
Location: Romania

Member

You could write a bash script that does this...

I don't think is very hard...

You look into /etc/vz/conf dir and construct a loop that searches config files and you read the veid from the filename.

After that you grep a status command on that veid and take the action that you want depending of the status.

Report message to a moderator

[Message index]

		DISCUSSION OVZ command to start/stop VE based on status. By: joelee on Sun, 08 July 2007 14:04
		Re: OVZ command to start/stop VE based on status. By: n00b_admin on Mon, 09 July 2007 10:00
		Re: OVZ command to start/stop VE based on status. By: joelee on Mon, 09 July 2007 11:20
		Re: OVZ command to start/stop VE based on status. By: curx on Wed, 11 July 2007 00:25
		Re: OVZ command to start/stop VE based on status. By: n00b_admin on Mon, 09 July 2007 12:13
		Re: OVZ command to start/stop VE based on status. By: joelee on Tue, 10 July 2007 19:19
		Re: OVZ command to start/stop VE based on status. By: Vasily Tarasov on Wed, 11 July 2007 07:41

Previous Topic:	BUG REPORTED vzmigrate with NFS
Next Topic:	KNOWN ISSUE Problems with online migration on 031 kernel

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 03 00:29:18 GMT 2025

Total time taken to generate the page: 0.70326 seconds