OpenVZ Forum: Support » Asterisk G.729 codec...

Home » General » Support » Asterisk G.729 codec...

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Asterisk G.729 codec... [message #14116 is a reply to message #14109]

Fri, 15 June 2007 06:21

Vasily Tarasov
Messages: 1345
Registered: January 2006

Senior Member

Just do not assign any IP addresses using "vzctl set <veid> --ipadd <ip address>" to the VE in question. In this way, you _will_ still have venet0 device inside VE, but it _will_ _not_ operate.

HTH,
Vasily.

Report message to a moderator

[Message index]

		Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 13:27
		Re: Asterisk G.729 codec... By: curx on Tue, 12 June 2007 15:49
		Re: Asterisk G.729 codec... By: ugob on Tue, 12 June 2007 16:35
		Re: Asterisk G.729 codec... By: curx on Wed, 13 June 2007 09:33
		Re: Asterisk G.729 codec... By: ugob on Wed, 13 June 2007 11:21
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Thu, 14 June 2007 10:04
		Re: Asterisk G.729 codec... By: ugob on Thu, 14 June 2007 19:51
		Re: Asterisk G.729 codec... By: Vasily Tarasov on Fri, 15 June 2007 06:21
		Re: Asterisk G.729 codec... By: ugob on Wed, 12 September 2007 12:09
		Re: Asterisk G.729 codec... By: ugob on Fri, 05 October 2007 16:39
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 12:59
		Re: Asterisk G.729 codec... By: ugob on Tue, 16 October 2007 13:08
		Re: Asterisk G.729 codec... By: bobot23 on Tue, 23 October 2012 23:30
		Re: Asterisk G.729 codec... By: ugob on Wed, 24 October 2012 17:40

Previous Topic:	vzctl exec command
Next Topic:	100% CPU usage

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Sep 03 01:40:46 GMT 2026

Total time taken to generate the page: 0.06577 seconds