OpenVZ Forum


Home » Mailing lists » Users » WARNING: No module aacraid found for kernel 2.6.8-022stab034.1, continuing anyway
Re: WARNING: No module aacraid found for kernel 2.6.8-022stab034.1, continuing anyway [message #141 is a reply to message #137] Thu, 22 September 2005 08:17 Go to previous message
dev is currently offline  dev
Messages: 1693
Registered: September 2005
Location: Moscow
Senior Member

> I'm trying to install openvz on RHEL 4, DELL PowerEdge 750. After
>
> # rpm -ihv vzkernel-2.6.8-022stab034.1.i686.rpm
>
> I get
>
> [root@redhat virtuozzo]# rpm -ihv vzkernel-2.6.8-022stab034.1.i686.rpm
> warning: vzkernel-2.6.8-022stab034.1.i686.rpm: V3 DSA signature:
> NOKEY, key ID a7a1d4b6
> Preparing... ########################################### [100%]
> 1:vzkernel ########################################### [100%]
> WARNING: No module aacraid found for kernel 2.6.8-022stab034.1,
> continuing anyway
> WARNING: No module ata_piix found for kernel 2.6.8-022stab034.1,
> continuing anyway
>
> Any help?
Actually it is just a warnings due to the fact that most IDE/SCSI
drivers are compiled in OVZ kernel and are absent as modules.
But RHEL provides these as modules, so it's tools are complaining a bit.

You can check that /boot/initrd-2.6.8-022stab034.1.img was still created
successfully or create it manually as dim@ wrote to you:

# mkinitrd --builtin=aacraid
--builtin=ata_piix /boot/initrd-2.6.8-022stab034.1.img 2.6.8-022stab034.1

Kirill
 
Read Message
Read Message
Read Message
Previous Topic: Re: Re: WARNING: No module aacraid found for kernel 2.6.8-022stab034.1, continuing anyway
Next Topic: Openvirtuozzo kernel patch license questions
Goto Forum:
  


Current Time: Sat Aug 23 20:42:18 GMT 2025

Total time taken to generate the page: 0.09264 seconds