OpenVZ Forum: Support » Private virtual network with multiple VPN and NAT

Home » General » Support » Private virtual network with multiple VPN and NAT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Private virtual network with multiple VPN and NAT [message #14022 is a reply to message #13984]

Mon, 11 June 2007 12:25

ovzuser
Messages: 6
Registered: May 2007
Location: Germany

Junior Member

Hi,

did you add HN's eth0 to the bridge? I don't understand your iptable stuff so just this idea...

Take care: eth0 will become a member of the bridge! Don't configure it as network device, configure the bridge instead. Means your HN will have a network device "vzbr0" which is used to communicate to outside world (including VEs). eth0 will _not_ have a ip-address any more.

I have done what you want to do with opensuse and it works. SuSE has a ifup-bridge script which does the details of setting up the brigde (but you can do it per hand of course). The veth-devices are added later during VE startup.

Tip: After adding a new device to a bridge, it takes 30s before data transmission. Look at brctl documentation. If you ping too early it can not work.

Markus

Report message to a moderator

[Message index]

		Private virtual network with multiple VPN and NAT By: jmslkn on Fri, 08 June 2007 17:39
		Re: Private virtual network with multiple VPN and NAT By: jmslkn on Mon, 11 June 2007 06:26
		Re: Private virtual network with multiple VPN and NAT By: ovzuser on Mon, 11 June 2007 12:25
		Re: Private virtual network with multiple VPN and NAT By: jmslkn on Mon, 11 June 2007 15:35

Previous Topic:	SUGGESTION Restructuring and Improving CONF files
Next Topic:	SOLVED New rev of the Live-cd?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Feb 16 01:55:20 GMT 2026

Total time taken to generate the page: 0.53703 seconds