networking, looking for pointers [message #13631] |
Thu, 31 May 2007 10:25 |
slybob
Messages: 20 Registered: March 2007
|
Junior Member |
|
|
We are having problems getting the VE's to see outside of the Vlan,
anyone got any ideas for debugging this? When I was using open VZ
before on a domestic netgear router, It just worked. The virtual machines could see in and I could route to the IP's I set no problem although the router couldnt see them as devices.
afaik, at the moment there is a cisco router connected to the pipe, with a firewall
connected to that, then my box is hooked into a switch which plugs
into the firewall (if that makes sense)
The sys admin has set up /24 vlan (192.168.101.0) for me
router routing table
S 192.168.101.0/24 [1/0] via 192.168.150.2
S* 0.0.0.0/0 is directly connected, FastEthernet0/0
192.168.150.2 is the firewall, below is the rule for my subnet.
192.168.101/24 link#5 UC 0 0 - hme2
Sorry if this doesn't make a lot of sense
Cheers,
Andy
How I learned to stop worrying and love SMTP
http://www.moonet.co.uk/
|
|
|