OpenVZ Forum


Home » Mailing lists » Devel » PPC64 Kernel 2.6.18 + RPM packages
Re: PPC64 Kernel 2.6.18 + RPM packages [message #13238 is a reply to message #13222] Wed, 23 May 2007 13:34 Go to previous messageGo to previous message
Christian Kaiser2 is currently offline  Christian Kaiser2
Messages: 27
Registered: May 2007
Junior Member
Alexey Dobriyan <adobriyan@sw.ru> wrote on 05/23/2007 03:06:10 PM:

> On Wed, May 23, 2007 at 04:41:03PM +0400, Kirill Korotaev wrote:
> > Christian Kaiser2 wrote:
> > > [root@s10b10-0 vzctl-3.0.16]# /etc/init.d/vz start
> > > Starting OpenVZ: [ OK ]
> > > Bringing up interface venet0: [ OK ]
> > > Configuring interface venet0: [ OK ]
> > > vzctl set 0 --cpuunits 1000 failed: Setting CPU units: 1000
> > > fairsched_chwt: No such file or directory
> > > WARNING: Settings were not saved and will be resetted to
> or[FAILED]alues on
> > > next start (use --save flag)
> > >
> > > What is "fairsched_chwt"? And why is it missing in my
> configuration?? An VE
> > > creation works fine:
> >
> > this is due to not set CONFIG_FAIRSCHED option in your kernel .config
file.
>
> It would return -ENOSYS then?
>

When, where and what should return "-ENOSYS"?

I rechecked my .config file and I've seen that
CONFIG_SCHED_VCPU=y
CONFIG_FAIRSCHED=y
is already in it. But I cannot find it in the menuconfig. The menu of
powerpc architecture is a bit different than i386. So perhaps I just
haven't seen it... where should I find it then?

So what I posted before is perhaps wrong. CONFIG_FAIRSCHED _was set_ in
.config file. But I got the error "fairsched_chwt: No such file or
directory".

Mit freundlichen Grüßen / Best Regards
Christian Kaiser
--
IBM Deutschland Entwicklung GmbH
Open Systems Firmware Development
mail: ckaiser2@de.ibm.com

IBM Deutschland Entwicklung GmbH
Vorsitzender des Aufsichtsrats: Martin Jetter
Geschäftsführung: Herbert Kircher
Sitz der Gesellschaft: Böblingen
Registergericht: Amtsgericht Stuttgart, HRB 243294

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: listhelp.h
Next Topic: [PATCH -mm] Fix /proc/slab_allocators re seq_list_next() conversion
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Aug 28 10:49:09 GMT 2026

Total time taken to generate the page: 0.29591 seconds
Powered by FUDforum Powered by Virtuozzo Containers