OpenVZ Forum: Support » using cdrom from inside VE

Home » General » Support » using cdrom from inside VE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: using cdrom from inside VE [message #12881 is a reply to message #12874]

Mon, 14 May 2007 09:36

Vasily Tarasov
Messages: 1345
Registered: January 2006

Senior Member

Hello,

1) `--devices b:3:0:r --save` does not create a device node in /dev. It only grants permissions to the device! You can use `--devnodes hda:r --save` command, which not only grants permissions, but aslo creates a node.

2) However, if you're using udev in VE (just check whether tmpfs is mounted on /dev, if it is so, then you're using udev), you need to create a device node inside VE manually once again:

vzctl exec <veid> mknod /dev/hda b 3 0

HTH,
Vasily.

Report message to a moderator

[Message index]

		using cdrom from inside VE By: goeldi on Mon, 14 May 2007 07:45
		Re: using cdrom from inside VE By: Vasily Tarasov on Mon, 14 May 2007 09:36
		Re: using cdrom from inside VE By: goeldi on Mon, 14 May 2007 09:42
		Re: using cdrom from inside VE By: Vasily Tarasov on Mon, 14 May 2007 10:27

Previous Topic:	VE_PRIVATE on GFS2
Next Topic:	NAT enabled but VE cannot communicate beyond HN

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Feb 16 10:16:49 GMT 2026

Total time taken to generate the page: 0.48180 seconds