| Re: [PATCH 0/9] Containers (V9): Generic Process Containers [message #12458 is a reply to message #12408] |
Sun, 29 April 2007 09:37   |
Paul Jackson
Messages: 157
Registered: February 2006
|
Senior Member |
|
|
I'm afraid that this patch set doesn't do cpusets very well.
It builds and boots and mounts the cpuset file system ok.
But trying to write the 'mems' file hangs the system hard.
I had to test it against 2.6.21-rc7-mm2, because I can't boot
2.6.21-rc7-mm1, due to the 'bad_page' problem that I noted in an
earlier post this evening on lkml.
These container patches seemed to apply ok against 2.6.21-rc7-mm2,
and built and booted ok. I built with an sn2_defconfig configuration,
having the following CONTAINER and CPUSET settings:
CONFIG_CONTAINERS=y
CONFIG_CONTAINER_DEBUG=y
CONFIG_CPUSETS=y
CONFIG_CONTAINER_CPUACCT=y
CONFIG_PROC_PID_CPUSET=y
# CONFIG_ACPI_CONTAINER is not set
I could mount the cpuset file system on /dev/cpuset just fine.
Then I invoked the following commands:
# cd /dev/cpuset
# mkdir foo
# cd foo
# echo 0-3 > cpus
# echo 0-1 > mems
At that point, the system hangs. Reproduced three times, on two boots.
I never get a shell prompt back from that second echo. I have to hit
Reset. The three different hangs were done with the following three
different values:
echo 0-3 > mems
echo 0-1 > mems
echo 1 > mems
On that last one, "echo 1 > mems", I did not do the echo to cpus first.
The test system had 8 cpus, numbered 0-7, and 4 mems, numbered 0-3.
--
I won't rest till it's the best ...
Programmer, Linux Scalability
Paul Jackson <pj@sgi.com> 1.925.600.0401
|
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
