OpenVZ Forum


Home » General » Support » Connecting VM eth0 to guest tap device
Re: Connecting VM eth0 to guest tap device [message #11862 is a reply to message #11859] Tue, 10 April 2007 08:39 Go to previous messageGo to previous message
HRogge is currently offline  HRogge
Messages: 16
Registered: April 2007
Junior Member
Exactly... unfortunately I cannot connect NS2 to anything, NS2 creates a tap device and I have to use it...

so I would need a way to put anything (including broadcasts) from the eth0 device in VE0 into the tap device and anything out of the tap device into the eth0. This traffic must not be limited by the mac/ip number of the eth0 device.

maybe I can do it the other way... if I allow VE to access a tap device on VE0 (found some doc about it in the wiki), can I tell VE to use this tap as a network device similar to eth0 ?
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: VPS&cPanel: High processor load
Next Topic: how to migrate vps's to new node?
Goto Forum:
  


Current Time: Wed Jul 17 20:20:58 GMT 2024

Total time taken to generate the page: 0.02727 seconds