OpenVZ Forum: Support » *SOLVED* Raid 10 problem?

Home » General » Support » *SOLVED* Raid 10 problem?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Raid 10 provlem? [message #10818 is a reply to message #10815]

Sun, 04 March 2007 17:14

rickb
Messages: 368
Registered: October 2006

Senior Member

Hi. When the fs goes into read only mode, what does "dmesg" say? If there are reports of block device problems, the problem is much different than if there is not.

From my experience, if you are seeing seek errors in dmesg, its a problem with the disks/controller however if there are no block level errors/reports, it is a problem with the md driver.

This may help you narrow it down a lot.

-------------
Common Terms I post with: http://wiki.openvz.org/Category:Definitions

UBC. Learn it, love it, live it: http://wiki.openvz.org/Proc/user_beancounters

Report message to a moderator

[Message index]

		SOLVED Raid 10 problem? By: mperkel on Sun, 04 March 2007 15:29
		Re: Raid 10 provlem? By: rickb on Sun, 04 March 2007 17:14
		Re: Raid 10 provlem? By: mperkel on Sun, 04 March 2007 17:20
		Re: Raid 10 provlem? By: mperkel on Mon, 05 March 2007 03:56

Previous Topic:	OpenVZ in action?
Next Topic:	Network Routing Question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed May 27 09:51:47 GMT 2026

Total time taken to generate the page: 0.37142 seconds