OpenVZ Forum


Home » General » Support » *SOLVED* Installation problem (urgent)
Re: Installation problem (urgent) [message #10494 is a reply to message #10489] Mon, 19 February 2007 22:05 Go to previous messageGo to previous message
Kutschka is currently offline  Kutschka
Messages: 24
Registered: February 2007
Junior Member
stoffell wrote on Mon, 19 February 2007 16:22

I had the same issue on sarge, if your initrd.img does not exist in /boot or /, create it:
cd /boot
mkinitrd -o /boot/initrd.img-2.6.18-028test015.1+31-ovz 2.6.18-028test015.1+31-ovz

Then link /initrd.img to the correct initrd.img:
ln -s /boot/initrd.img-2.6.18-028test015.1+31-ovz /initrd.img

Re-run lilo -v and see if it's okay now..




No:(

/usr/sbin/mkinitrd: add_modules_dep_2_5: modprobe failed
FATAL: Module ext2 not found.
FATAL: Module ext3 not found.
FATAL: Module xfs not found.
FATAL: Module reiserfs not found.
FATAL: Module raid1 not found.
FATAL: Module 3w_xxxx not found.
FATAL: Module 3w_9xxx not found.
FATAL: Module sata_via not found.
FATAL: Module sata_sil not found.
FATAL: Module sata_nv not found.
FATAL: Module amd74xx not found.
FATAL: Module sd_mod not found.
WARNING: This failure MAY indicate that your kernel will not boot!
but it can also be triggered by needed modules being compiled into
the kernel.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: locale errors
Next Topic: *SOLVED* sparc64 SunBlade 1000: irrecoverable deferred error trap
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Jan 24 06:48:32 GMT 2026

Total time taken to generate the page: 0.37951 seconds
Powered by FUDforum Powered by Virtuozzo Containers