| Re: DL380 G2 - CCISS [message #10382 is a reply to message #10368] |
Fri, 16 February 2007 18:03   |
gramsa49
Messages: 17
Registered: February 2007
|
Junior Member |
|
|
| Vasily Tarasov wrote on Fri, 16 February 2007 02:02 |
Hello,
There is a strange thing in your post. The step of "building some drivers using the kernel sources" goes before the step of "installing ovzkernel-smp". Drivers are always build against certain version of kernel. So, I guess, you should build them after ovz kernel is installed (and booted?)
However this doesn't explain the error...
Can you tell me, please, does CentOS 4.4 kernel with no additional drivers boot normally?
Thanks.
|
The CentOS kernel does boot normally without the compaq drivers in place, though the devices are not fully functional (there is a tape drive attached to the scsi bus).
Chances are I need to start over and run the compaq smartstart installation, which builds the compaq drivers, after the openvz kernel is in place. I will do this tonight and post the results.
|
|
|
|
OpenVZ Forum
Members
Search
Help
Register
Login
Home
