OpenVZ Forum


Home » Mailing lists » Users » Networking Question
Re: Networking Question [message #1014 is a reply to message #1013] Thu, 26 January 2006 09:26 Go to previous messageGo to previous message
dev is currently offline  dev
Messages: 1693
Registered: September 2005
Location: Moscow
Senior Member
Hello Greg,

> I am having a problem with the networking on my Gentoo VPS. I figure I better
> start at the beginning and make sure I have the OVZ host "hardware node" set
> up the preferred way. I checked the user guide briefly last night and did not
> find an answer to my question. If i have a server with 10 external IP's do
> those 10 IP's have to be listed in
> /etc/sysconfig/network-scripts/ifcfg-eth0-range0? Currently I DO NOT have the
> IP's homed to the hardware node. I let "vzctl add 101 --ipaddr xxx.xxx.xxx.xxx
> --save" add them for me to the guest. Just as an experiment I added a script
> ifcfg-venet0-range0 to add the IP's to the hardware node but the script was
> rewritten on startup of the network so I guess that is not the answer. There
> is no sense getting into the specifics of my issue with networking until I
> confirm the correct way to set up the hardware note to begin with. So..
>
> Do I need to home the external IP's in the hardware node under ifcfg-eth0 ??
the IPs you intend to use for VPSs should not mentioned in ifcfg-eth0.
vzctl will setup appropriate routing rules in host system for these IPs
on VPS start.

can you give me the access to you node (in private email only)? this
could allow us much quicker to solve the problem.

Kirill

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Anyone know if ReactOS will run over OpenVZ?
Next Topic: Re: OpenVZ and Gentoo (partly solved)
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 02 10:07:02 GMT 2026

Total time taken to generate the page: 0.19797 seconds
Powered by FUDforum Powered by Virtuozzo Containers