OpenVZ Forum: Support » *SOLVED* problems creating veth device: "Bad parameter for --veth

Home » General » Support » *SOLVED* problems creating veth device: "Bad parameter for --veth_add: ..."

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: problems creating veth device [message #9779 is a reply to message #9778]

Mon, 22 January 2007 08:29

Bubba Ho-Tep
Messages: 3
Registered: January 2007
Location: Oz

Junior Member

Sorry not sure I understand you...

"As I can see in your commndline "eth0" persists"

do you mean

$ vzctl set 101 --veth_add veth101.0, a_made_up_MAC_address, eth0, a_made_up_MAC_address+1 --save

the eth0 in the line above? Isn't this the virtual Ethernet device which I'm creating?

Or do you mean the ".0" part of veth101.0? I just copied the format from the wiki and assumed the same format.

BHT

Report message to a moderator

[Message index]

		SOLVED problems creating veth device: "Bad parameter for --veth_add: ..." By: Bubba Ho-Tep on Mon, 22 January 2007 03:32
		Re: problems creating veth device By: Vasily Tarasov on Mon, 22 January 2007 06:48
		Re: problems creating veth device By: Bubba Ho-Tep on Mon, 22 January 2007 08:29
		Re: problems creating veth device By: Andrey Mirkin on Mon, 22 January 2007 10:27
		Re: problems creating veth device By: Bubba Ho-Tep on Mon, 22 January 2007 23:49

Previous Topic:	OpenVz support for Network Checkpointing
Next Topic:	Trouble starting/accessing Gentoo VPS

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Aug 04 13:19:48 GMT 2025

Total time taken to generate the page: 1.59875 seconds