OpenVZ Forum: Support » accessing USB devices from a VE

Home » General » Support » accessing USB devices from a VE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

accessing USB devices from a VE [message #7830]

Thu, 26 October 2006 20:10

n8behavior
Messages: 2
Registered: October 2006

Junior Member

hello,

i am trying to install an application in a VE (i.e. did a vzctl enter) that requires the presence of a hardware dongle. this is a USB device that the installer looks for before continuing. it also must be there each time the app starts up. i can find the device in /proc/bus/usb/devices from the host.

How do I grant access to a USB device?

Report message to a moderator

Re: accessing USB devices from a VE [message #7831 is a reply to message #7830]

Thu, 26 October 2006 20:23

n8behavior
Messages: 2
Registered: October 2006

Junior Member

if it helps, i have found that my VPS's do not have /proc/bus

where as, VE0 does have /proc/bus ...of course.

Report message to a moderator

Re: accessing USB devices from a VE [message #7840 is a reply to message #7830]

Fri, 27 October 2006 07:10

Vasily Tarasov
Messages: 1345
Registered: January 2006

Senior Member

Hello,

The question is how application you're installing find out the precense of dongle device...
I suppose it should look not in /sys/*, but rather in /dev/*. If it is so, then just export device in question to VE using:
--devnodes parameter of vzctl (look in vzctl man page for further information).

HTH,
vass.

Report message to a moderator

Previous Topic:	ipv6 and tspc
Next Topic:	To many open files

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Aug 03 17:27:46 GMT 2026

Total time taken to generate the page: 0.61182 seconds