OpenVZ Forum: Support » VENET, VETH + SNAT

Home » General » Support » VENET, VETH + SNAT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: VENET, VETH + SNAT [message #7634 is a reply to message #7623]

Thu, 19 October 2006 10:59

Andrey Mirkin
Messages: 193
Registered: May 2006

Senior Member

SNAT can be performed only with routing, i.e. you will need to remove eth0 and eth1 interfaces from bridges and configure correct route table and SNAT on HW node.

Andrey Mirkin

http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]

		VENET, VETH + SNAT By: chinaman on Wed, 18 October 2006 07:10
		Re: VENET, VETH + SNAT By: Andrey Mirkin on Wed, 18 October 2006 07:48
		Re: VENET, VETH + SNAT By: chinaman on Thu, 19 October 2006 08:48
		Re: VENET, VETH + SNAT By: Andrey Mirkin on Thu, 19 October 2006 10:59
		Re: VENET, VETH + SNAT By: chinaman on Thu, 19 October 2006 12:48
		Re: VENET, VETH + SNAT By: Andrey Mirkin on Thu, 19 October 2006 15:03
		Re: VENET, VETH + SNAT By: chinaman on Fri, 20 October 2006 07:07
		Re: VENET, VETH + SNAT By: Andrey Mirkin on Fri, 20 October 2006 09:52
		Re: VENET, VETH + SNAT By: chinaman on Fri, 20 October 2006 10:26
		Re: VENET, VETH + SNAT By: Andrey Mirkin on Fri, 20 October 2006 10:58

Previous Topic:	Startup script on slack
Next Topic:	SOLVED vpsid shows no pid

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Feb 17 18:23:06 GMT 2026

Total time taken to generate the page: 0.14940 seconds