OpenVZ Forum: Support » *SOLVED* Help with ethernet adaptor

Home » General » Support » *SOLVED* Help with ethernet adaptor

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Help with ethernet adaptor [message #6319 is a reply to message #6299]

Thu, 14 September 2006 06:19

Vasily Tarasov
Messages: 1345
Registered: January 2006

Senior Member

Hello,
In OpenVZ kernel driver for these devices is compiled as a module.
So, the most probable thing is that you haven't loaded it.

If you have only remote access you can do the following:

1) Reboot into non-OpenVZ kernel, where network works.
2) Login on the node via ssh and edit /etc/modprobe.conf by adding kinda "alias eth0 8139too" or "alias eth0 8139cp" or ...
I don't know exactly your model and number of cards you use. Provide `lscpi -n` and `lspci` output to clarify it.
3) Try to reboot in OpenVZ kernel.

After that module should loads automatically.

HTH,
vass.

Report message to a moderator

[Message index]

		SOLVED Help with ethernet adaptor By: Jonathon on Wed, 13 September 2006 17:46
		Re: Help with ethernet adaptor By: mkl0815 on Wed, 13 September 2006 19:08
		Re: Help with ethernet adaptor By: Jonathon on Wed, 13 September 2006 19:13
		Re: Help with ethernet adaptor By: Vasily Tarasov on Thu, 14 September 2006 06:19
		Re: SOLVED Help with ethernet adaptor By: Jonathon on Thu, 21 September 2006 07:43

Previous Topic:	SOLVED DNS Problem
Next Topic:	QM_MODULES function not implemented -> install module-init-tools!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Sep 01 15:36:03 GMT 2026

Total time taken to generate the page: 0.71791 seconds