Re: Multiple IP - Speed? [message #6076 is a reply to message #6063] |
Thu, 07 September 2006 17:02 ![Go to previous message Go to previous message](/theme/ovz3/images/up.png) |
chinaman
Messages: 15 Registered: August 2006
|
Junior Member |
|
|
Andrey Mirkin wrote on Thu, 07 September 2006 11:04 |
chinaman wrote on Thu, 07 September 2006 09:37 | 1. I add veth and eth0 device to bridge in HW node. I had to set a route to IP of VPS to veth device, otherwise I couldn't reach the VPS. Is this correct? I thought there is no routing necessary bcs. of the bridge.
|
Just add route to this VPS via bridge interface (veth in bridge, so everything should work fine).
|
Yes, you are right, now it's working fine. Propably i did something wrong before.
Andrey Mirkin wrote on Thu, 07 September 2006 11:04 |
chinaman wrote on Thu, 07 September 2006 09:37 | 2. How can I automatically assign IP to eth0 device in VPS? If i use /etc/network/interfaces the file is empty after restarting VPS.
| You can use DHCP daemon to assign IP addresses for VPSes.
|
I tried a bit and I used the config start filed <VEID>.start to handle this problem. The file has to be located in /etc/vz/conf (just latest version of vzctl)
In the file i used:
ifconfig eth0 0
ip addr add 192.168.0.1/32 dev eth0
Andrey Mirkin wrote on Thu, 07 September 2006 11:04 |
chinaman wrote on Thu, 07 September 2006 09:37 | 3. After restarting the VPS the veth dev in HW was down. I had to do the whole procedure (adding to bridge ...) manually again. Is it possible to do this automatically?
| Unfortunately it is not yet automated. But you can add necessary commands to <VEID>.start script, so veth device will be configured on VPS start.
|
I tried, but the configuration of the veth device in HW isn't working with <VEID>.start. It seems this file is running inside the starting VPS. So i used it to set the IP. (see above)
It would be nice if there would be a script running inside the HW like <VEID>.start is running inside the VPS.
Thanks for all the help!
I would say the problem is solved.
[Updated on: Thu, 07 September 2006 17:12] Report message to a moderator
|
|
|