OpenVZ Forum


Home » General » Support » *SOLVED* Multiple IP - Speed?
Re: Multiple IP - Speed? [message #6063 is a reply to message #6061] Thu, 07 September 2006 15:04 Go to previous messageGo to previous message
Andrey Mirkin is currently offline  Andrey Mirkin
Messages: 193
Registered: May 2006
Senior Member
chinaman wrote on Thu, 07 September 2006 09:37

1. I add veth and eth0 device to bridge in HW node. I had to set a route to IP of VPS to veth device, otherwise I couldn't reach the VPS. Is this correct? I thought there is no routing necessary bcs. of the bridge.

You couldn't reach VPS from HW node? Just add route to this VPS via bridge interface (veth in bridge, so everything should work fine).
chinaman wrote on Thu, 07 September 2006 09:37

2. How can I automatically assign IP to eth0 device in VPS? If i use /etc/network/interfaces the file is empty after restarting VPS.
You can use DHCP daemon to assign IP addresses for VPSes.
chinaman wrote on Thu, 07 September 2006 09:37

3. After restarting the VPS the veth dev in HW was down. I had to do the whole procedure (adding to bridge ...) manually again. Is it possible to do this automatically?
Unfortunately it is not yet automated. But you can add necessary commands to <VEID>.start script, so veth device will be configured on VPS start.

Andrey Mirkin
http://static.openvz.org/userbars/openvz-developer.png

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: IPV6 Support in VPS
Next Topic: Setting up VZ Partitions?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Sep 02 05:27:26 GMT 2026

Total time taken to generate the page: 0.50777 seconds
Powered by FUDforum Powered by Virtuozzo Containers